Broadband, low-noise and power microwave amplifiers
Master Thesis
1986
Permanent link to this Item
Authors
Supervisors
Journal Title
Link to Journal
Journal ISSN
Volume Title
Publisher
Publisher
University of Cape Town
Department
License
Series
Abstract
The design of Broadband, Low-Noise and Power Microwave Amplifiers using microstrip softboard technology is investigated. The software program TOUCHSTONE (TM) by EEsof is used extensively as a basic design tool. The characterisation of the GaAs Field Effect Transistors, used for the amplifiers, is carried out. These characterisations are then used by the program in its circuit analysis. A determination of the validity of using the manufacturer's data, for the designs, is determined by comparing it to the measured data. Source-Pull and Load-Pull measurements were performed for the Power GaAs FET characterisation. The noise-parameter device characterisation is carried out in a similar way to that for Load-Pull data. Each amplifier required final tuning adjustments in order to peak the performances. The Broadband Maximum Gain Amplifier had a 10 ± 1.5dB gain over a bandwidth from 2- to 6-GHz. The Low-Noise amplifier achieved 5dB Noise-Figure and 5.4 ± 1. 4dB gain over the 2- to 6-GHz band. The Power amplifier Output Power was 390mW over the 3.7- to 4.2-GHz band. Techniques of broadband matching are investigated, with Double-Stub matching producing the widest bandwidth. A literature survey is presented on aspects of broadband microwave amplifiers, as well as a survey on Computer-aided-design at microwave frequencies and techniques of Large-Signal Transistor characterisation.
Description
Reference:
Hall, A. 1986. Broadband, low-noise and power microwave amplifiers. University of Cape Town.