L-band RFI measurement system simulation and investigation
Master Thesis
2007
Permanent link to this Item
Authors
Supervisors
Journal Title
Link to Journal
Journal ISSN
Volume Title
Publisher
Publisher
University of Cape Town
Department
License
Series
Abstract
The Square Kilometre Array (SKA) is a multi billion dollar international project to create a receiving surface of a million square metres, one hundred times larger than the biggest receiving surface now in existence. The SKA core array will have to be located in a remote area. Therefore countries interested in hosting the SKA core array were requested to perform Radio Frequency Interference measurements at their site of choice. The systems that are to be used in the measurements must conform to a document called the "RFI Measurement Protocol for Candidates SKA Sites", the SKA Memo 37. The RFI protocol divides measurements into two parts, Mode 1 and Mode 2. Mode 1 is defined for the observation of strong RFI and is relevant for SKA receiver linearity analysis. Mode 2 is defined for the observation of weak interferences, which potentially threatens to obscure weak signals of interest. In Mode 1, the RFI protocol specifies a dwell time of 2μS duration over a large 1 MHz bandwidth in the 960 -1400 MHz band (L-band). The reason for this short dwell time is to capture and characterize pulsed interference from radars and Distance Measuring Equipment (DME) in this band. This kind of interference is expected, potentially with very high peak power and short dwell time. Executing these measurements with the spectrum analyzer is impractical because of the very long measurement times. It was therefore proposed to build a dedicated FFT spectrometer from standard components, state of the art FPGA board with a high speed 14 bit ADC.
Description
Includes bibliographical references (leaves 53-54)
Keywords
Reference:
Mngadi, A. 2007. L-band RFI measurement system simulation and investigation. University of Cape Town.